12/31/2023 0 Comments Atc scm11 dual binding posts![]() ![]() Recommended Power Amplifier: 75 to 300 WattsĬonnectors: Binding Posts/4mm Plugs, bi-wireĬabinet Dimensions (HxWxD): 381 x 232 x 236mm / 15.00 x 9.21 x 8. Signal-to-Noise ratio (S/N) ≥108dB (A Weighted, ref.45W)ĭrivers: HF ATC 25mm Neodymium soft dome, Mid/LF ATC 150mm CLDĭispersion: ☘0° Coherent Horizontal, ☑0° Coherent Vertical There's good reason why the stupendous-sounding ATC SCM11 v2 bookshelf loudspeakers have won multiple awards from What Hi-Fi and proclaimed by the audiophile journal to be the 'most talented standmounters anywhere near this price.' Offering big, spacious performance and sterling transparency, SCM11 v2 is distinguished by its effortlessly. Connectors: Binding Posts/4mm Plugs, bi-wire Cabinet Dimensions (HxWxD): 300x174x215mm (grill adds 28mm depth) Weight: 7.5kg. Total Harmonic Distortion (THD) <0.009% (10W, 1kHz) Handle high spl effortlessly, and work well even very close (within a few inches) to a back wall. Sharing technology with the renowned ATC. Non-fatiguing, see-through clarity, and they literally disappear when working with them. The four passive and two active loudspeaker systems in the Entry Series are the first to employ ATCs SH25-76 tweeter. After reading through the forum found that some people have paired the Cambridge Audio 851W with the SCM11s and the results were quite good. Have had the ATC SCM20psl Pro mkii for a few years now and they are simply superb. However, I thought the rega was very much inadequate for the speakers. I also have the option to add a power amp and use the vena as a preamp, so any ideas if necessary in this direction welcome.įrequency Response -0.5Db (20Hz-20kHz,ref.1kHz) Hi, following the reviews on this site, I ordered a rega Elicit-R and a pair of ATC SCM11. Am wondering whether I can get away with using the vena? Flat impedance curve allowing easy load for amplifiers. In-house, hand-wound precision flat wire coil. CLD driver technology with 45mm integral soft dome. However, it’s for a small room and moderate levels. New ATC designed and built 25mm soft dome HF unit with precision alloy wave guide. The vena spec is below (basically 45w / channel) which is lower than the 75 atc recommend. Am pursuing a pair of scm11’s, however, I know Atc’s like a bit of welly.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |